THE ENDUROCO 2wd hiace lift kit

The EnduroCo Hiace 2WD Lift Kit has been designed from the exclusive EnduroCo 4×4 Conversion Kit for the Toyota Hiace Commuter Bus and work van which is the preferred choice for passenger transport buses, 4×4 ambulance vehicles and mining service vehicles operating in remote locations and off-road conditions.

The EnduroCo Hiace 2WD Lift Kit was designed and tested for on road and off-road applications where 4×4 vehicles were not required; however, a requirement for an increase in suspension and body lift under the vehicles is required due to uneven, degraded and rough road conditions.

Providing 100mm of suspension lift and an increase of 350-450Kg GVM across the entire Hiace and Commuter range, the 2WD lift kit is a cost effective and advantageous solution perfectly suited to fleet and trades-people vehicles where an increase in GVM and lift allows for carrying larger capacity loads and navigating work sites with ease.

The 2WD High Lift Kit incorporates;
Heavy duty lower control arms
Heavy duty extended steer knuckles
Heavy duty castor rods
Uprated rear leaf springs
Uprated front shock absorbers
Uprated rear shock absorbers
Increased ride height by 100mm
GVM increase across all models
New uprated inner tie rods
Extended brake hoses
Bump stop relocation mounts
Full Engineering Compliance on conversion*
*When installed by EnduroCo only.

 

WATCH BELOW

The EnduroCo Hiace / Commuter 2WD Lift kit is a direct bolt in solution; available for any workshop to install themselves.
Check out this detailed instructional video of EnduroCo technicians converting a standard Hiace to gain some much needed lift!

GET IN TOUCH!